To make sure the commercial roofing services Franklin Park you choose is suitable for your requirements and the building it will be put on, it is crucial to understand each component before beginning the commercial roof replacement Franklin Park.
When replacing a flat roof, choosing the proper flat roofing material is one of the most crucial choices to make, but there are other crucial factors to take into account as well, such as the roof’s slope and the drainage system. Both the roof’s insulation level and its structural support system should be taken into account.
The following information about commercial roof replacement Franklin Park and key factors to think about will help you proceed with getting your flat roof replaced effectively.
Roof Pitch
Although the phrase “flat roof” often implies that the roof is totally level, even a flat roof requires a little slope. This will assist keep water from collecting and harming property. When the slope is not taken into consideration, the most frequent issues arise on flat roofs. Roof damage results from improper drainage, which is caused by a poor slope. The ideal roof slope is one that is at least 14 inches per foot.
Drainage
The removal of water from your flat roof is mostly dependent on the roof drainage system. Even flat roofs with a correct slope require a place for the water to drain.
- Interior Drains – In metropolitan places, interior drains are often seen. They let water exit the building and connect to the drainpipes that go to the sewer or storm drains. When using internal drains, you should exercise care. You might have flooding or sewer discharge if the drains become blocked, freeze, and then burst.
- Scuppers – Scuppers are drains that are built on the roof’s side and allow water to flow freely to the ground. Because they are not linked to pipes used for interior plumbing, scuppers won’t clog if they are broad enough, and there are no hazards of damaged pipes because they are not connected to pipes for indoor plumbing.
- Downspouts And Gutters – The conventional method of enabling water to drain from a building are via the use of gutters and downspouts.
R-Value
The R-Value describes how insulated the roof is. It is a gauge of an insulation’s capacity to stop heat from passing through. The thermal performance increases as the R-Value increases. R-Values vary depending on the kind of insulation used. A good R-value is provided by polyisocyanurate insulation, often known as polyiso.
Architectural Load
The structural load is a crucial factor to take into account when rebuilding your roof. What will be placed on the structure is referred to as the structural load. You may reduce the number of flat roofing materials you can employ by understanding how much weight your building can support. If there is any uncertainty, be sure to speak with a structural engineer.
Replacing Vs. Repairing
Lastly, confirm if the roof needs to be replaced. It is usually better to replace your roof if the cost of maintenance has increased to a point where it exceeds the cost of a new roof. However, there are several situations when commercial roof repairs may be performed to assist the flat roof last longer. If you’re unsure, be sure to contact a flat roof specialists to get their advice. It’s time to hire a professional to replace the roof after you have whittled down your selections. A flat roof replacement may be less expensive than you anticipate, depending on the materials you choose. Need help? Contact us!
